International Coatings 7014 LB NP HP Legacy White Plastisol Ink
Legacy White™ is a low bleed, high pigment, fast flashing, low tack, non- phthalate plastisol screen printing ink.
7014 Legacy White™ is a low bleed, high pigment, fast flashing, low tack, non-phthalate plastisol screen printing ink.
7014 Legacy White™ has a creamy viscosity and medium body, making the ink suitable for both, auto and manual processes.
7014 Legacy White™ offers superior performance through fast production speeds, its brightness and opacity.
7014 Legacy White™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should just dry to the touch, with no lift-off, but not totally fused. Totally fusing the underprint white may cause inter-coat adhesion problems with the inks printed on top of the white ink. Final fusing or curing occurs in the dryer.
7014 Legacy White™ is a low bleed ink, not a non-bleed ink. On some types of fabric, bleeding or dye migration may occur. Always test-print the fabric to be printed before beginning production. It is best to do some long term testing on fabrics to determine if they are going to bleed. Bleeding or dye migration may not occur right away.
7014 Legacy White™ was formulated to make printing opaque white easy. Hand printing is less tiring because less squeegee pressure is needed. The result is improved operator performance. Automatic equipment can be adjusted to lower pressure settings, thus improving screen life, squeegee durability and overall print quality.
7014 Legacy White™, compared to other opaque whites, prints easily. You will find that a finer screen mesh can be used to achieve the same opacity as a more open mesh. This means less ink will be needed, a real money saver in terms of ink usage. It also means a softer hand on flashed fabrics.
Adding any reducers or additives can lower bleed resistance, reduce opacity, or increase cure times of the ink. STIR the ink prior to printing on press and after addition of reducers or additives.
Test dryer temperatures and wash test printed product before and during a production run.
50/50 Cotton/Polyester Blends
60-230 t/in (24-90 t/ cm monofilament
65-75 Durometer Sharp edge
STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight. Keep containers well sealed
Feel free to live chat with us if you have any questions.